Steps to install the Lenovo ZUK Z1 Flash File (Firmware ROM)
Now, we hope that you have fulfilled all the requirements that we have mentioned above. After that, you will have to follow all the steps that we have mentioned below to install the Lenovo ZUK Z1 flash file. Follow the steps in the same order as we have mentioned.
You will first have to download the Qualcomm USB driver on your system. You will then have to follow all the instructions appearing on the screen to complete the installation process. In case you have the driver on your system, you may skip this step.
Once done, you will have to download the Lenovo downloader tool on your system and then extract the contents of the tool to another folder.
Now, in the tool folder, you will have to look for the QcomDLoader.exe file and then click on it to start the tool.
After this, in the tool window, you will have to look for the load button and then click on it. You will then have to click on the select button so that you can redirect the software to the location where you have stored your firmware.
Once done, you will have to click on the start button to begin the process.
Now, you will have to switch off your device. You will then have to press the Volume Up and Down button and keep holding it. Simultaneously, you will have to connect the device to the system without leaving the buttons.
Once done, wait for the tool to detect the device. Once the tool will detect the device, the process will start on its own.
After this, you will have to wait for the flashing process to end.
After the process will end, you will have to close the tool window and disconnect the device from the system.