Many people are not aware of how to install a flash file to update the firmware on the device. If you also do not know, this article can be helpful for you. Here is the original Micromax Bolt A075 flash file and all the information regarding the same. We have mentioned how you can install the Micromax A075 flash file ( Firmware Stock ROM) with the help of an SPD tool. Stay tuned to the article to know more about it.
Things to Remember
So, before you can start the process, there are certain things that you will have to do. These things will help you to carry out the process smoothly.
- The very first thing that you need is to have some basic knowledge about the process. Off the chance you do not know, you will have to seek help. Always remember that this tutorial is valid for a particular process only.
- Next, you will have to make sure that you download the firmware file and the tool file from an authenticated source. Always use the drivers that are compatible with the device. The drivers are available on the internet.
- Also, you need to scan all the files so that you can be sure that they are safe to use on the system.
- You would know that you will lose all the data post flashing, so, you need to create a backup of all the data available on the device for later use.
- Always remember to charge your device completely or at least up to 70 percent so that you can use the device till the end of the process.
Steps to Install Micromax Bolt A075 Flash File
Now that you have fulfilled all the requirements that we have mentioned in the above section of the article, here is how you can proceed with the process. Below we have mentioned all the steps that you will have to follow to install the Micromax Bolt A075 flash file. Go through all the steps properly and follow in the same way as mentioned.
- To start with, you will have to download the SPD driver on your system. You will then have to click on the downloaded file to start the installation process. Follow all the instructions appearing on the screen to complete the installation process.
- After this, you will have to download the stock firmware file for your device. You will then have to extract the contents of the firmware file.
- Once done, you will have to download the SPD upgrade tool on the system, and then you will have to extract the tool files also.
- Now, open the extracted tool folder and then click on the upgrade download file. It will open the tool window for you.
- In the tool window, you will have to click on the load packet option and then you will have to redirect the tool to the folder in which you have extracted the firmware file.
- Select an appropriate firmware file and then click on the select option.
- You will now have to turn off the device and then connect it to the system with the help of a USB cable.
- After this, you will have to click on the start option to begin the flashing process.
- Wait for the process to complete. When the process will complete, you will get an upgrade successful message on the screen.
- Finally, terminate the tool window and detach the cable. Turn on your device.
Download Micromax Bolt A075 Stock Firmware ROM (Flash File)
So, this is it. This was the full process that you need to follow to install the Micromax A075 flash file. We have provided you with all the valid and correct information. We hope that the article was helpful.